Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This test report show you the procedures on how to use Autek iKey820 programmer to add new G chip key for Toyota Coralla.
Procedures:
Connect Autek iKey820 programmer to Toyota Corolla,then select “KEY PROGRAM”
Select “Toyota”–>”BY VEHICLE”–>”Corolla”–>”2013″–>”KEY”
Now please turn the ignition ON by working key 
After communication building,select “ADD KEY” 
Then remove working key from ignition and insert it and turn ignition ON again. 
Within 20 seconds,turn ignition OFF and remove key 
Insert new key you want to add into ignition with ignition off
Wait a minute,it will prompt you with “SUCCESS” massage
Doen!Test the new key on vehicle.
And for more Autek iKey820 programmer:
http://www.chinaobd2.com/vp-autek-ikey820-ikey-820-car-key-programmer.html
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!