Skip to content
Menu
OBD2 Scanner Blog
  • Home
  • Car Diagnostic Tool
    • MB Star Diagnosis
    • BMW Diagnostic Tool
    • GM Tech2
    • Volvo Vocom Interface
  • OBD2 Code Scanner
    • VXDIAG
  • Tech Support
OBD2 Scanner Blog

Audi A6 C5 reversing alarm system trouble (real case)

Posted on February 24, 2019February 24, 2019 by VCDS

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Audi A6 C5 equipped with ultrasonic reversing alarm system, commonly called as Parking Sensor.Contain the reverse alarm control unit J446, reverse alarm buzzer H15, rear bumper installed on the four reversing alarm sensor G203, G204, G205, G206, multi-function switch F125 reversing signal and other components.(picture 1)

Audi A6 C5 reversing alarm system trouble (real case)

It use to monitor obstacles rear of car 0.2 ~ 1.5m when you back up, in case of obstacles issued a buzzing alarm.

A Audi A6 2008 reversing alarm system get trouble.I test the car with owner,and observe parking sensors surface without damage.

Altrasonic reversing alarm system trouble possible reasons:

1.Parking Sensors fault
2.reverse switch fault
3.Control unit fault
4.Line fault

Dianoses:

Use VAS 5052 to check out address code 76 reverse alarm control unit J4467,and not found trouble code.When test car find reversing signal light off,it provided by the multi-function switch F125.If J446 will not receive the reverse signal,the reverse alarm system will be disabled.

According to circuit diagram(picture 2),fuse S231 provides multi-function switch F125 positive, if S231 fuse, F125 will not issue a reversing signal.I find fuse S231 has been blown,and circuit is not found on the ground short circuit fault.After repalcing the S231,reverse alarm system is working properly.But 30 mins later,S231 fuse again.It is found there exist ground short circuit under the S231.

Audi A6 C5 reversing alarm system trouble (real case)

There is a set point A38 in the circuit diagram.It provide positive voltage to legs line.It shows that several branches may exist on the ground short circuit. Take the exclusion method, one by one to disconnect the branch of the electrical plug,measuring successively.There is still short to the ground under S231 fuse.It indicating that the ground short circuit is located in the wire.
Continue to check the harness, find the engine compartment of the computer box plug was wet with coolant. After inspection,it come form the expansion water tank. Water droplets to the engine harness, wiring harness into the computer box plug.

Finally,replace the expansion tank and clean the plug at the computer box. Test, reverse alarm system back to normal.

How useful was this post?

Click on a star to rate it!

Average rating / 5. Vote count:

Related Posts
Original Handy Baby 2 II Key Programmer Hand-held Car Key Copy Key Programmer for 4D/46/48 Chips
Audi A6 C5 reversing alarm system trouble (real case)

Handy Baby 2 II Key Programmer Hand-held Car Key Copy Key Programmer for 4D/46/48 ChipsNote: Language: English, SpanishThis Device can't work together Read more

Renault CAN Clip V175 and Consult 3 III For Nissan Professional Diagnostic Tool 2 in 1
Renault CAN Clip V175 and Consult 3 III For Nissan Professional Diagnostic Tool 2 in 1

Renault CAN Clip V175 and Consult 3 III For Nissan Professional Diagnostic Tool 2 in 1 Descriptions of Consult 3 Read more

Super VAG K+CAN V4.6 With Multi Language
Super VAG K+CAN V4.6 With Multi Language

Super VAG K+CAN V4.6 Top 3 Reasons To Get Super VAG: Software Version: V4.6Supported Languages: English/ Spanish/ Italian/ Portuguese/ GreekUDS Protocol Read more

V3.9 CG100 Airbag Restore Devices Support Renesas
V3.9 CG100 Airbag Restore Devices Support Renesas

New CG100 Airbag Restore Devices Support Renesas   Top 5 Reasons to Get CG100: 1. Operating Systems:XP/WIN7/WIN8/32bit/64bit 2. Including All Function Read more

This Post: Audi A6 C5 reversing alarm system trouble (real case) From ChinaOBD2 Official Blog
Please keep this link if you copy the post!

Tags: cat

Post navigation

Prev: Prev: How to reset Light Control Module(LCM)BMW E60 2006
Next: Next: Toyota Camry Steering Locked ECU trouble result in can

Leave a Reply Cancel reply

Your email address will not be published. Required fields are marked *

Recent Posts

  • How to Remove and Replace Cab Heater Controls for JCB 3CX Loader
  • How to Remove Differential Gear for FENDT 900 Vario COMIII
  • Quick Tips to Use Xhorse BMW G Series BDC2 Adapter
  • International MaxxForce 7 SPN 27 FMI 4 EGRP Signal Out of Range Low
  • Detroit DD13 SPN 84 FMI 3 MCM Vehicle Speed Sensor Open Circuit

Recommend OBD2 Scanner

ME9.7 ECU Engine Computer ME9.7 ECU Engine ComputerTabScan T6PT3G Diagnosis VCI for Porsche Diagnostic Tool Porsche Diagnostic Tool

Recent Comments

  • VCDS on Scania SDP3 2.59.1 free download Scania Diagnosis & Programming 3 download link
  • Glynn McKay on Scania SDP3 2.59.1 free download Scania Diagnosis & Programming 3 download link
  • jakub brosz on Scania SDP3 V2.64.3 Download link
  • amr on MAN EOL Flash File Editor + MAN Immo Calculator Free Download
  • Pasquale Greenwald on Jungheinrich ETM/V 10-12 Tightening Torque for Screwed Connection on Brake Systems

Archives

Categories

  • BMW Diagnostic Tool
  • Car Diagnostic Tool
  • Key Cutting Machine
  • Key Programming Tool
  • MB Star Diagnosis
  • OBD2 Code Scanner
  • Tech Support
  • VXDIAG

Tags

adapter Auto Pick and Decoder Car Key Copy Car Key Programmer cat Code Reader diagnostic software ECU Chip Tunning ecu programmer Ford gm handy baby Handy Baby 2 Key Programmer Handy Baby II Key Programmer HEX V2 immo iprog key Key Pro key programmer laptop Launch lish LISHI new arrivals nexiq nexiq link diesel truck interface nexiq truck diagnostic NEXIQ USB Link OBD2 obdii original program Scania VCI smart VAG COM Cable VCDS VCDS Cable VCDS VAG COM Cable vci VW wholesale X-PROG Box X-PROG Box ECU Programmer XPROG-M

Hot Selling

  • Launch CRP129 HD
  • ME 9.7 ECU Engine Computer
  • MINI VCI J2534
  • NCF29XX Programmer

Links

  • BOBD2 Auto Diagnostic Tools Market
  • China OBD2
  • EPS Foam Machine
  • Foxdiag
  • Сканер OBD2
©2025 OBD2 Scanner Blog | Powered by chinaobd2