AGCO EEM4 Engine K5004 Air Filter Pressure Sensor Active at Init State

This instruction show you guide on how to solve AGCO EEM4 engine trouble code K5004,air filter pressure sensor active at initial state.More repair case for JCB,please refer to:JCB Trouble Repair

 

Related Content:

WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download

2020 JCB ServiceMaster 4 Free Download for Win XP,Win 7,Win 8,Win 10

 

The air filter pressure sensor indicates blocked filter even though engine is not running.

Possible causes are:

The air filter pressure sensor wiring is defective.

The air filter sensor is defective.

 

Reaction in EEM

The FC is stored and the warning lamp is activated. The CAN message indicates active fault.

 

Solution

First save the error log and then erase it. Restart the ECU after erasing the error log. If the fault occurs again during the next driving cycle, check the following paths:

Check the air filter pressure sensor wiring, the connectors and the contact surfaces of the connector pins (possible oxidation).

Check the operation with another air filter pressure sensor to see if the air filter pressure sensor is defective.

This Post: AGCO EEM4 Engine K5004 Air Filter Pressure Sensor Active at Init State From ChinaOBD2 Official Blog
Please keep this link if you copy the post!