EWS Immo Emulator for BMW
Function:
This device can emulate BMW EWS 2 and EWS 3.2 immobilizer (EWS module) in cases when original system restore is impossible
(faulty EWS, lost or damaged transponders, continuous problems with rolling codes etc.)
How to use BMW EWS Immo Emulator?
1. Remove original EWS2 control unit, find +12v ACC, GND, K-line
2. Disconnect emulator from K-line; connect K output from emulator to
3. DME (DDE) <-> EWS line.
4. Don’t forget to short two starter relay wires (EWS connector)!
5. Car is ready to start.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!