ELM327 V1.5 Plastic OBDII EOBD CANBUS Scanner Without FT232RL Chip

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

ELM327 V1.5 Plastic OBDII EOBD CANBUS Scanner without FT232RL Chip

Top 7 Reasons To Get USB ELM327 V1.5:

1. Supports protocols – ISO 9141-2 and ISO 14230-4 as well as CAN Bus ISO 15765-4.

2. Internal EEPROM can remember the last protocol.

3. Precision-moulded diagnostic connector made to fit all VW/Audi vehicles, even those with "tight" trim around diagnostic socket.

4. USB port.

5. Voltage input monitors your vehicle’s battery.
6. Software Version: V2.1
7. Hardware version: V1.5

USB ELM327 V1.5 Technical Specification:

ELM327 Based – Datasheet

OBDII Plug: J1962 16-Pin Male (to Car)

USB Port : (to Computer or PDA)

High quality UL certified USB Cable (equivalent to CE).

CAN (ISO 15765-4)

ISO 9141-2

ISO 14230-4

Automatically searches for the correct protocol or can be configured manually.

USB Port

Serial Interface uses AT commands to look like a modem.

Status LED

Length with USB Lead : 1.5 metres

What’s New for elm327 plastic 1.5:

General Items:

RS232 baud rates to 500 Kbps

Adaptive Timing automatically adjusts ST timeouts

Power up to AT MA is selectable

Source (tester) address can be changed

Can reset all PPs with a jumper

Receive addresses can be independently set

Power Control with a low power standby mode

A 4800 baud ISO option

A non-volatile memory location for storing user data

CAN extended addressing support

You can now perform ISO/KWP bus initializations without having to send a request

An SS command allows searching through the OBD protocols sequentially

A new TA command allows the Tester Address to be easily changed

Factory calibration for the voltage reading circuit can be easily restored

ISO 9141 and ISO 14230:

The slow initiation address can now be varied

Control over key word checking

KWP protocols can now transmit 3 or 4 byte headers

CAN:

New J1939 protocol

Two user-definable CAN protocols

Improved error handling and recovery

Extended addressing support

How To Use USB ELM327:

1. Turn the car’s ignition switch ON. No need to start the engine.

2. Start the software program, click "Options", select the correct communications port.

3. Your interface now works! Make sure the software can reliably access all the control modules that it should in your car.

Package including:

1pc x ELM327 V1.5 Interface

1pc x CD Driver

ELM327 V1.5 Plastic OBDII EOBD CANBUS Scanner Without FT232RL Chip

How useful was this post?

Click on a star to rate it!

Average rating / 5. Vote count:

This Post: ELM327 V1.5 Plastic OBDII EOBD CANBUS Scanner Without FT232RL Chip From ChinaOBD2 Official Blog
Please keep this link if you copy the post!

Tags: ELM327

Leave a Reply Cancel reply