This function resets all adaptive values in an engine and it needs to be performed when sensor related repair or part replacement is done to an engine.
Procedures:
Connect G-scan2 to vehicle by OBD port,enter menu to select “DIAGNOSIS”
Select “CITROEN”
Note:Automatic selection is added in 2019 January update.
Select “C3(A51)(2013-)”3
It show the vehicle information:VIN,MODEL,ENGINE and YEAR
Select “Special Function”
Select [Initialization of the autoadaptive values]
Make sure to meet the precondition described in the beginning of calibration:
IG ON
The fan assembly should not be operating
Do not start the engine for 10 minutes before performing this operation
The air conditioning must be OFF
The battery voltage must be above 12V
Switch off the ignition
It will take about 1 minute to perform
Note:This part is edited for 5 times faster than original footage
Operation completed
Switch off the ignition and switch it on again
Done!
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Related Posts
ICOM A2+B+C For BMW Diagnostic & Programming Tool With ISTA-D 4.12.12 ISTA-...
2018.12.17
OBDSTAR DP plus user manual: compare x300 DP, updates, how to’s etc.
2023.03.8
WinOLS Disable/Close FAP and DPF for EDC16C34
2019.07.22
How to solve VW 2004 Touareg airbag warning light on
2019.02.24
How to Use Immo Killer 1.0 to Disable BMW 93C46 IMMO
2019.07.24
How to Cut Ford Transit FO21 TIBBE Key by Xhorse Dolphin XP-005 with M3 Clamp
2023.04.2
BMW 35160 & 35080 EEPROM Odometer Correction By Yanhua 35xx Emulator
2019.02.24
Using a Diagnostic Car Code Reader You Don’t Need to Go to the repair shop
2019.02.27
US$157.00-2019 Latest Version X-PROG Box ECU Programmer Shipping from Uzbekistan
2019.02.27
How to Use E-sys Flash EU Fxx N53 DME and EGS
2019.07.24