This instruction show the steps on how to use FCOM to re-configuration of an ECU using AS-BUILT data function for Ford Focus 2008.
Preparations:
FCOM Ford OBD2 Diagnostic Software Download
How to Install FCOM Diagnostic Software on Window/Linux
Procedures:
Connect FCOM interface to vehicle OBD port,then run FCOM software
Click “Select Control Unit”
Select “IPC-Instruments panel cluster”
Select “Configuration” under “Expert functions”
Select “As-Built data”,then click”Go” to continue
Select “720-01-01,2C69 0040 807E”,then click “Exit”
Here input “CD7201408029”
Click “Write configuration to ECU”
It will show below warning massage,click “Yes” to continue
Reprogramming successfully
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Related Posts
UPA Programmer & NYO 4.0 Change Mileage for Renault ESPACE HC908AZ60
2020.10.11
John Deere Service Advisor 5.3.225 (replaces 5.2) Offline 2023 Construction and ...
2024.01.28
How to Reset VW Steering Assist 1S1909144P with OBDSTAR X300 DP?
2019.03.6
How to Use OPCOM to Adjust Clutch & Gear Adaptation Easytronic
2019.05.14
How to Program 8C Key for Mazda 323 Manually
2019.02.24
Honda Odyssey 2016 All Key Lost Programmign by Autek iKey820
2023.06.10
How to Replace and Program New BCM for Opel Corsa-D
2019.03.21
Volvo PROSIS Parts Catalog & Repair Manuals Free Download
2019.07.27
OBDSTAR IMMO Update more American cars (GM, Ford, Chrysler, Lincoln…)
2019.03.13
How to Initialize Nissan TEANA J31 Immobilizer System
2019.07.22